Console Zone Indicators

The Console displays the status of the first eight zones.  These indicators can display four states, as follows:

Steady on - means that particular door or window is open.

Steady off - means that particular door or window is closed.

Slow Flashing - means that particular Door/Window Sensor is reporting a problem.

Fast Flashing - means that a particular Door/Window Sensor reported a problem and the fault was bypassed, or the door/window is open and has been bypassed.

All Door/Window Sensors and Motion Detectors report-in to the Console about every 90 minutes.  If the Console does not receive a signal from the sensor within 4 hours, it reports a problem with that sensor by slowly flashing the appropriate zone indicator.  If you try to arm the system while a zone indicator is flashing, the Console sounds a repetitive trouble alarm.  Either press [DISARM], correct the problem and press [ARM] again, or press [BYPASS] while the trouble alarm is sounding, then press [ARM].  The zone(s) with a problem will not be armed and the zone indicator(s) will flash rapidly.  All other zones will arm.

If you bypass an open window and arm the system, and later close the window, that zone will now be armed.

Arming and Disarming the System

When you arm the system in the RUN 1 or RUN 2 mode, and open a door or window, the following happens:

• A loud siren sounds for 4 minutes.
• Lights connected to Lamp Modules and Wall Switch Modules flash on and off.
• The automatic dialer dials the first phone number stored and plays back your message.

When armed, RUN 1 and RUN 2 modes are the same, opening a door or window trips the alarm.  When the system is in RUN 2 mode and not armed, the Console sounds a pleasant chime when you open a door or window.  In RUN 1 there are no chimes.

Instant Mode

1. If using the Master Remote, set its Delay switch to MIN.

2. Press [ARM].  The Console emits two tones and the ARMED indicator turns on.

Open a door or window, the alarm instantly trips, the siren sounds, lights connected to Lamp and Wall Switch Modules flash on and off, and the dialer dials out.

3. Press [DISARM] to stop the siren.  The lights remain on.

4. Press [LIGHT OFF] on the Remote Control to turn off lights connected to modules which you set to the same House code and Unit Code as the Console.

  
next >